Knowledge

Portable solar trailer for CCTV surveillance

Mar 13, 2023 Leave a message

Portable solar trailer for CCTV surveillance, the camera shall be provided by customer as requested

 

The spec requirements for trailer is as below. 

 

Setup

i. Electro-Hydraulic lift or Electro-winch with cable raises sign display on tower

ii. Tower rotates 360 degrees for optimal positioning

iii. Single disk brake holds display in place during operation, while a cradle supports and holds display in travel position

 

Power system

i. Battery powered and solar charging

ii. Stand by Generator back up if Battery power drained

iii. Auto change-over system shall be available between Solar and Generator System

iv. Energy-efficient operation results in long run times

v. Solar panels charge batteries automatically without intervention

vi. Charging system shuts down when batteries are fully charged, preventing damage

vii. Power system allows battery charging with solar panels or commercial power

viii. Cooling fan protects battery charger from overheating

ix. Battery box can be locked to prevent unauthorized access

 

Trailer

i. Frame All welded structural steel

ii. Fenders Round full wheel coverage fenders with inner splash panel on each fender. Fenders are bolted to the trailer frame.

iii. Material: 16ga steel

iv. Finish Frame is coated with oven-baked, safety-orange powder-coat finish to ensure durability and corrosion protection.

v. Axle assembly 2000 lb. (907kg) capacity, 5 on 4.5" B.C. idler hub

vi. Tires ST205/75D15 steel-belted trailer tires, load rating B

 

Drawbar

i. Tow Centre Standard 2-inch ball coupler tow-hCentreh, SAE Class 2, 3500-lb. (1588kg) capacity. Bolts to drawbar, removable and replaceable.

ii. Tow chains Two high-test proof coil chain assemblies, with “latching” S-hooks for towing. Chains attached to drawbar with quick connectors.

iii. Working load limit 5400 lbs. (2450kg)

iv. Breaking force 16,200 lbs. (72kN)

v. Stabilizer jacks Four swivel jacks, each with 2000-lb. (907kg) capacity, mounted on corners of trailer frame

vi. Wind resistance in the deployed position, the maximum sustainable wind speed before overturning, when supported by the standard jack stands with tires off the ground, is 72 mph (115km/h)

vii. Turn and taillights Two oval-shaped, sealed, combination stop.

viii. No screws used for mounting; bracket is welded to trailer frame; each light held in place and sealed with snap-in rubber grommet

ix. Reflectors Sides of trailer have amber reflectors near front and red reflectors near rear

x. Wiring Description Wiring to connect tow vehicle and trailer for trailer taillights is installed inside drawbar, with pigtails and connectors at both ends; no crimping required

xi. Trailer plug A sealed, moulded, 4-square connector plugs into harness under trailer

xii. Tow-vehicle plug Two-piece assembly with 4-flat moulded connector on harness plugs into tow vehicle

xiii. Protection All trailer wiring encased in UV protective loom, and attached with P-clamp riveted to trailer frame; no exposed wires

xiv. light weight trailer for easy lifting, transportation and installation

 

Send Inquiry