Request for Quotation
Mobile Solar Trailer
Scope:
This RFQ is to quote a mobile solar trailer, delivered to the US. Included in this document are the configurations, quantities to quote, incoterms and custom requirements.
Timeline:
Please advise the timeline for when model/drawings can be sent for review with customization and lead time for the first unit.
BIGLUX :We will supply two solutions of 4*450W model/drawings for you tomorrow.
One solution is our standard design.
4units loaded by 1*40HQ container (4*450W solar panel trailer).
The other solution is customized design.
5units loaded by 1*40HQ container (4*450W solar panel trailer).
Configuration:
4 x 450W monofacial panels with 4 batteries
4 x 450W monofacial panels with 8 batteries
6 x 450W monofacial panels with 4 batteries
6 x 450W monofacial panels with 8 batteries
4 x 600W monofacial panels with 4 batteries
4 x 600W monofacial panels with 8 batteries
BIGLUX : all these configurations are fine for us to customize design for you. But we need your confirmation of which container loading plan would you like to have about above mentioned two solutions? can you accept 1*40HQ container to load just 4 units? because if you choose 6*450W solar trailer design, then we have only one loading plan, which is 4units loaded by 1*40HQ container.
Quantities to quote:
40 and 100 units.
BIGLUX: OK, we will quote you accordingly after your confirmation.
Incoterms:
DDP
BIGLUX: OK
Shipping Quantities:
Minimum of 5 per 40HQ with request to improve on this quantity.
BIGLUX: as above mentioned, different configuration has different container loading plan, we need your decision of which container loading plan would you prefer to have.
4units loaded by 1*40HQ container (for both 4*450W and 6*450W solar panel trailer).
5units loaded by 1*40HQ container (for 4*450W solar panel trailer only).
See following pages for customizations and requirements.
RIO 2.0 Manufacturing Requirements
The vendor shall quote manufacturing units as follows:
Trailer
All parts are new.
OK
Single-axle trailer
OK
Axle, suspension springs, hubs, wheels, tires designed to support weight of whole assembly plus 50% safety margin.
OK
Trailer has hitch to fit standard 2-inch ball.
OK
Hitch can only release when a release lever or button is pressed.
OK
Hitch allows for a padlock to be installed to lock hitch on ball.
OK
Trailer has safety chains.
OK
Trailer has fenders.
OK
Trailer has all lights and reflectors as attached “tp14117e.pdf” document.
OK
All lights are LED.
OK
Trailer has wiring harness to connect lights to towing vehicle using standard connector.
OK
Trailer has mounting points for license plate, having two holes with 7-8 mm diameter on
180 mm centres.
OK
Trailer wheels have minimum diameter of 14 inches.
OK
Trailer tires are marked with:The letters "DOT" indicating compliance with NHTSA safety standards.
A tire identification number (TIN) indicating the manufacturer and other tire specifications.
The maximum load carrying capacity of the tire, also known as the maximum load rating or maximum load index.
The tire size designation, which includes the tire width, aspect ratio, and wheel diameter.
OK
Trailer tires are rated for highway speeds of 80 km/h minimum.
OK
Trailer is marked permanently with a vehicle identification number (VIN).
OK
Trailer has four extendable outriggers to level and stabilize the trailer when parked.
OK
Trailer has a retractable caster wheel to support the trailer when the outriggers are not used.
OK
The center of mass is forward of the axle.
OK
The weight measured at the tongue is 10-15% of the unit’s total weight.
OK
Trailer has channels for lifting with forklift.
OK
Mast
The unit has a telescoping mast capable of 4.5 to 5.5 meters above ground level.
OK, for this, we also have two options:
*we have standard hot sale 6.5m telescopic mast, which you can just lift up @ 5meters or less or more;
* but we can also customized design telescopic mast with 5meters for you, so total height above the ground level could be about 5.5m.
The mast is electrically operated and can fully extend or retract in less than 40 seconds.
OK, no problem;
The mast controls are in a locked cabinet.
OK, no problem;
here is a coiled electrical connection between the base unit cabinet and the ROSA:
Minimum one pair of power cables, minimum 13 AWG.
Minimum one ethernet cable, CAT5e or better.
OK, no problem
Pair of power cables are terminated with Molex 1700010102.
OK, no problem
Photovoltaic
Panels are 72 cell (144 half-cell) or higher.
Ok, no problem
When not in used, panels stow away to occupy minimum space.
OK, no problem
Angle of panels can adjust to between 30 and 50 degrees from the horizon.
OK, our current standard trailer panel can adjust to between 20~35degrees,not to 50 degree, is it enough for you? If not enough, we can customize design for you.
Battery
Charging
Uses lead-acid gel or lithium chemistry batteries, having a total capacity of at least 10000Wh.
OK, no problem
Battery and all electronics are in a locked cabinet.
OK, no problem
Charge controller can use all power generated by solar panels.
OK , no problem
Documentation
Vendor will provide 2D and 3D CAD models of all components and assembly.
Before confirming order, we can supply you 2D or 3D document in PDF version for your reference. After confirming order, we can give you 2D and 3D CAD models.
Here are links for the above mentioned products.
https://www.bigluxled.com/solar-cctv-tower/mobile-solar-cctv-tower-construction-site.html
https://www.bigluxled.com/mobile-solar-trailer/mobile-surveillance-solar-trailer-for-public.html

